Skip to main content
Try for free

Replace material on a job

Supply replacement material to a job in progress.

Updated Nov 5 2026

Who this is for

Operators ask for more parts when they scrap, break or run short of something on a job. Warehouse staff pick the replacement and bring it to the floor. Supervisors approve large requests where your company requires it.

Applies to
Production
Inventory

Why it matters: a part request records why extra material went into the job. Without it, the stock goes missing from the shelf with no reason, and the job's cost leaves out the scrap.

  1. Request the replacement parts

    1. Open the work order (Production > Orders > Production Order List, then the order number). Click Parts, then View All Parts.
    2. Find the part and click Req More in its Request Parts column. You can only request parts on the job's BOM or the line's own part. Anything else shows Part request for "{part}" is not allowed. Choose a part from the line temp BOM or the line part.
    3. In Request More Parts, type the Qty you need. Tick Request Is Due To Scrap? if the parts were scrapped.
    4. Pick the Reason, such as Scrap, Build Error or Missing Part (your company sets the list), and add Comments.
    5. Click Send. Cetec shows Part Request Created (# {number}). If your company requires approval for requests over a set value, the request waits until someone approves it.
  2. Pick the parts to the request

    1. Open Production > Part Request List and click the request number.
    2. Check the Part, Qty Requested, Order, Request Reason and Requested By.
    3. In the bin list, type how many you take from each bin in Qty Picked.
    4. Set the status to Picking Complete and click Update. Cetec shows Request Updated and the request moves to Pending Receipt.
    5. If there is no stock, set the status to Pending Stock instead, so the floor knows it is waiting.
    6. The extra parts show on the work order's Pick Parts as picked.
  3. Deliver and close the request

    1. Take the parts to whoever asked for them.
    2. On the part request, set the status to Pick Complete & Close Request and click Update. Cetec shows Request Closed With Qty {n} Picked. Closing a request needs the Manager or PartRequestAdmin role. Without it, Update does nothing and shows no message, so leave it to your supervisor.

Other ways to do this

See how much was scrapped

  1. Open Production > Part Request List and click Filters.
  2. Set Scrap to Only Scrap and Active to All. Closed requests are hidden until you set Active.