Report on quality
Determine where defects concentrate and how often.Updated Nov 5 2026
Who this is for
Quality managers report pass rates and defect trends to management, customers and auditors. Production supervisors use the same reports to see which lines and locations need attention.
Applies to
Why it matters: a pass rate tells you whether quality is getting better. The failure codes tell you what to fix first.
-
Run the inspection summary
- Open
Production > Quality > Inspection Report. - Set the
Daterange, and filter byCustomer,Inspection TypeorPassif you need to.Passis the inspection's pass number (1st, 2nd …), not pass or fail. - Choose how to group the results in
View By:Error Code,Production LineorWork Location. - Click
Submit. Cetec shows one table for each inspection type (Source/Receiving, In Process, Final) and pass number. - Read
Qty Inspected,Qty Passed,Qty Failed,Pass Percent,Fail PercentandPPM(defective parts per million) for each group, and theTotalrow. Inspections with no production line or location are counted in theTotalbut get no row, so the rows can add up to less than the total.
- Open
-
Find what is failing
- Open
Production > Quality > Inspection Failures. The list opens with the last month of failures. - Click
Filters. Pick theDate FromandDate Toin the calendars, and filter byFailure Code,Work Order,TLA(the top-level assembly part),Work LocationorWarehouse Locationif you need to. ClickApply. - Click
Show Chartsto see Failures By Code: a bar chart of how many failures each failure code had. - Read the rows for each failure's
Work Order,TLA,Comp#,Comp PartandRef Designator, to trace it to the board or assembly.
- Open
Other ways to do this
List the inspections themselves
You want the inspections rather than the failures.
- Open
Production > Quality > Inspection Details.
Take the numbers into a spreadsheet
- On any of these reports, click
Export. On the Inspection Report, each inspection type's table has its ownExport.